Is it possible to modify the buffer+ to have an even higher input impedance?
It is possible to modify the buffer+ to increase the input impedance, but in order to do so you'll have to remove the input loading trim pot so you...
Fri, 8 Aug, 2014 at 12:54 PM
I ran my buffer+ on 12V for a few hours, have I done any harm?
No harm done at all. We recommend using 9V supplies as they're more efficient but the regulator will handle up to 18V no problem so you've got not...
Mon, 11 Aug, 2014 at 9:10 AM
How does the input pad work on looper pedals?
From the signal chain block diagram picture below, you'll see that the input pad is applied between the "guitar in" and "loop out" ...
Tue, 2 Dec, 2014 at 2:14 PM
How does the noise filter work on looper pedals?
The noise filter works by increasing high-end frequencies (where the hissy noise is) going into the loop, then reducing those frequencies back down. So say ...
Wed, 5 Apr, 2017 at 4:31 PM
Does the boost switch "engage" the buffer+?
No, the buffer is always on regardless of the boost switch.
Tue, 12 Aug, 2014 at 10:55 AM
Buffer+ Manual
Looking for the buffer+ manual?  Here it is!  (download below)
Thu, 3 Oct, 2019 at 1:55 PM